Xiamen UNT Duct Material Co.,Ltd
Office: No. 492 Hengtian Road, Jimei District, Xiamen City, Fujian, China
Factory: No. 15 Building, Yongding Industrial Park, Longyan City, Fujian, China
Manual bending machine is a kind of can be carried out on the thin plate bending machine, the structure mainly includes the bracket, workbench and clamping plate, workbench on the scaffold, workbench consists of base and the clamp, the base through the hinge is connected with the clamping plate, the base is composed of shell, the coil and plate, coil placed inside the shell of the sag, the depression at the top of the cover plate.
Classification of bending machine
The bending machine is divided into manual bending machine, hydraulic bending machine and nc bending machine.manual bending machine is also divided into mechanical manual bending machine and electric manual bending machine. According to the synchronous mode, the hydraulic bending machine can also be divided into: Torsion shaft synchronization, machine fluid synchronization, and electro-hydraulic synchronization.the hydraulic bending machine can be divided into two types according to the motion mode: Upward movement and downward movement.
Characteristics of manual tube bender
1. All-steel welded structure with sufficient strength and rigidity;
2. Drive on the hydraulic pressure, and the oil cylinders at both ends of the machine tool are arranged on the slider to directly drive the sliding work;
3. The slider synchronization mechanism adopts torsional axis to force synchronization;
4. Adopt mechanical block structure, stable and reliable;
5. Quick adjustment of sliding block stroke, manual adjustment, counter display;
6. Oblique wedge deflection compensation mechanism to ensure high bending accuracy.
Use of hand bending machine
Press the normal hydraulic bending machine processing
1. First, turn on the power, open the key switch on the control panel, and then press the oil pump to start.
2. Travel adjustment. When using the bending machine, attention should be paid to adjusting the travel, and the test should be conducted before bending.there must be a thickness gap between the bottom and the bottom of the bending machine.otherwise, the mould and machine will be damaged.the stroke adjustment also has the electric quick adjustment and the manual fine tuning.
3. The choice of bend groove is generally 8 times the width of plate thickness.if bending 4mm plate material, about 32 slot should be selected.
4. The rear baffle adjustment generally includes electric quick adjustment and manual fine-tuning. The method is the same as the shearing machine.
5. Step down the foot pedal switch and start bending. Unlike the plate cutter, the bending machine can be loosened at any time.